Announcement

Collapse
No announcement yet.

What size throttle boddies for a 16v?

Collapse
This is a sticky topic.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #46
    Originally posted by sandy309
    I'm satisfied that cutting the scuttle provides sufficient cold air.
    Thats good to know, it will be interesting to see what the engine makes in and out of the car to compare.

    Comment


    • #47
      is a gasket needed?

      HI :
      is a gasket needed when fitting inlet manifold ?
      thanks

      Comment


      • #48
        The standard 16v manifold uses foam o-rings. If you're fitting a TB manifold, use an adhesive sealer, my preferred is Loctite 5699 Grey.

        Comment


        • #49
          thanks

          thanks sandy

          Comment


          • #50
            intersting to see some of our very old development work in the graphs from our old dyno.

            As for the debate aboiut size- the MAXI and the KIT CARs used 48mm taper bodies.

            Steven

            Comment

            Working...
            X