Announcement

Collapse
No announcement yet.

PugSport Mounting

Collapse
This topic is closed.
X
This is a sticky topic.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • PugSport Mounting

    Did this on my last rallye, and now on this one. The back box rubber hangers tend to slide forward and end up slipping off, so i drilled a pilot hole (1mm iirc) then a slightly larger hole (3mm i think it was) to slide a split pin through, into the hanger on the underside of vehicle, and placed a metal washer between the rubber and the split pin. Best done with exhaust off the car for obvious reasons
    Voila



    Anyone fancy stickying this so it doesnt get lost???
    Last edited by philmh; 08-11-2009, 07:46 PM.
    :

  • #2
    Good idea. I saw someone else do something similar, put a thread on the end of it basically and then just put a nyloc nut on but this is a much simpler way to go about it!

    Comment


    • #3
      As per Peugeot Sport build manual!
      Mike
      www.106maxi.co.uk
      - North West Sports & Saloons Class F 2014 Champion
      - Winner of Dave Simpson Memorial Trophy

      - Britcar 24hour 2015, 2nd in class, 14th O/A
      - Seat Supercopa

      Comment

      Working...
      X